Before You Start Playing; Attaching The Pedalboard (At-90S); Opening/Closing The Lid; Setting Up The Music Stand - Roland 60S Owner's Manual

Before You Start Playing

Attaching the Pedalboard
(AT-90S)
1.
Detach the pedal cable that is temporarily
fastened to the board on the upper part of the
Expression Pedal.
2.
Connect the pedal cable to the connector located
at the right side of the Pedalboard.
3.
Slide the Pedalboard firmly all the way back so
that it is secure and unable to move.
fig.00-21
NOTE
Do not remove the fastener located near the Expression
Pedal. Before transporting the AT-90S, be sure to wind up the
pedal cable so that there is no slack, and attach it to the
fastener.

Opening/Closing the Lid

fig.00-22
1.
To open the lid, hold it with both hands and lift it
straight up. Then, slide it to the rear.
2.
To close the lid, slowly pull it forward until it
stops. Then, gently lower it into place.
18
NOTE
Be careful not to get your fingers caught when opening or
closing the lid. Adult supervision is recommended when
small children are going to be using the instrument.
NOTE
To prevent accidents, be sure to close the lid before moving
the organ.
NOTE
Make sure you don't have anything (such as sheet music) on
the keyboard when you close the lid.

Setting Up the Music Stand

fig.00-23
(2)
1.
Lift the music stand gently.
2.
Adjust the metal latches as shown in the
illustration above.
(AT-90S only)
3.
To set up the music stand, always use both hands
to lift the base, and pull it gently toward yourself.
fig.00-24
(1)
(2)