Installing the keyboard
1
Hold the keyboard and route the keyboard cable and the keyboard backlight cables through the palmrest in the system.
2
Align the keyboard with the screw holders on the system.
3
Replace the screws to secure the keyboard to the system.
4
Turn the system over and connect the keyboard cable and the keyboard backlight cable to the connector in the system.
NOTE:
When reinstalling the chassis frame ensure the keyboard cables are NOT under the lattice , but run through the
opening in the frame before connecting them to system board.
5
Install the:
a
keyboard lattice
b
battery
c
base cover
6
Follow the procedure in
Heat sink
Removing the heat sink
1
Follow the procedure in
2
Remove the :
a
base cover
b
battery
3
To remove the heat sink :
a
Remove the four (M2x3) screws that secure the heat sink on the system board [1].
NOTE:
•
Remove the heat sink screws in sequential order as indicated on the heat-sink.
b Lift the heat sink from the system [2].
30
Disassembly and reassembly
After working inside your
computer.
Before working inside your
computer.