Installing the battery
1
Insert the battery into the slot on the system.
2
Route the battery cable through the routing channel.
3
Tighten the M2x6 captive screw to secure the battery to the system.
4
Connect the battery cable to the connector on the system board.
5
Install the
base
cover.
6
Follow the procedure in
SSD card–optional
Removing the SSD card
1
Follow the procedure in
2
Remove the :
a
base cover
b
battery
3
To remove the Solid State Drive (SSD) card:
a
Peel the adhesive mylar shield that secures the SSD card [1].
NOTE:
Remove the adhesive mylar carefully so that it can be reused on the replacement SSD.
b Remove the M2x3 screw that secures the SSD to the system [2].
c
Slide and lift the SSD from the system [3].
18
Disassembly and reassembly
After working inside your
computer.
Before working inside your
computer.