Turning Off The Power; Adjusting The Volume; Adjusting The Display Contrast ([Display Contrast] Knob) - Roland RD-300GX Owner's Manual

Roland rd-300gx owner's manual

Hide thumbs Also See for RD-300GX:

Table of Contents

Getting Ready

Turning Off the Power

Before you turn off the power, move the volume down all the way by moving the

VOLUME slider.

Also completely turn down the volume of any connected audio device and other equipment.

Turn off the power to connected external devices.

Press the [POWER] switch on the back of the RD-300GX.

The power is switched off.

NOTE

fig.00-11

Adjust the volume using the VOLUME slider.

Move the slider up to increase the volume, or down to lower it.

Also adjust the volume of the connected devices to an appropriate level.

The characters in the display may be difficult to view immediately after turning on the power or

after extended use; this may also be because of where and how the display is situated.

In such instances, adjust the display contrast by turning the [DISPLAY CONTRAST] knob on the

rear panel.

fig.00-17p

If you need to turn off the power completely, first turn off the [POWER] switch, then unplug the

power cord from the power outlet. Refer to "Power Supply" (p. 6).

Table of Contents