Support; Status Of Leds On Front Panel - Bodet NETSILON 7 User Manual

8. sUpport

8.1 status of leDs on front panel

The LEDs can provide Netsilon status information.
status and
leD
colour
Off
Power
Constant green
Red
Off
Constant green
Red
Sync.
Flashing red
Off
Alarm
Flashing red
64
Description
No power supply
Power supply OK
Power supply fault
No synchronisation on input
Synchronisation OK
Synchronisation lost
Holdover function
Synchronisation lost
Holdover exceeded / freerun
No alarm
Critical alarm
Check that...
1) The mains (AC) power supply cable is
connected to a Netsilon connector and the
power supply switch is ON.
2) The direct current (DC) wires are
connected to the connector.
-
1) In the double supply version (100-240VAC
+ 18-36VDC), both power supplies are wired
correctly.
1) The priority synchronisation input is
available (e.g. for a GPS synchronisation
source, check that Netsilon is connected to
this antenna).
-
1) The priority synchronisation input is
available (e.g. for a GPS synchronisation
source, check that Netsilon is connected to
this antenna).
2) The GPS antenna installation is
operational (where applicable).
Please note: If Netsilon has just been
restarted, no troubleshooting is necessary.
Wait several minutes until the
synchronisation is detected.
1) The priority synchronisation input is
available (e.g. for a GPS synchronisation
source, check that Netsilon is connected to
this antenna).
2) The GPS antenna installation is
operational (where applicable).
-
Please note: If Netsilon has just been
restarted, no troubleshooting is necessary.
Wait several minutes until the
synchronisation is detected.
1) When synchronisation is lost and the
holdover has expired, check that the priority
synchronisation input is available (e.g. for a
GPS synchronisation source, check that
Netsilon is connected to this antenna).