Specifications - Makita JS3201 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Max. cutting capacities
Min. cutting radius
Strokes per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
DOUBLE INSULATION
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
-1
)
Overall length
Net weight
Safety class
with household
equipment and
environmentally compatible
2
2
2
2
END201-5
Noise
The typical
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
waste
Vibration
The vibration
determined according to EN60745:
its
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENE037-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENF002-2
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
2
JS3201
3.2 mm (10 ga.)
2.5 mm (13 ga.)
1.5 mm (17 ga.)
4.0 mm (9 ga.)
50 mm
1,600
213 mm
3.4 kg
/II
A-weighted noise level
) : 81 dB(A)
pA
) : 92 dB(A)
WA
Wear ear protection
total value (tri-axial
) : 17.0 m/s
h
2
ENG905-1
determined
ENG900-1
vector sum)
2
ENG901-1