Black BLK-CPD207VH Quick Installation Manual

BLK-CPD207VH 650 Line Indoor
IR Camera Quick Installation Guide
This document guides you through the basic steps to install and use your BLK-CPD207VH camera. The
camera includes 2.8-12 mm lens, OSD setup menus, and 12 Vdc or 24 Vac powering.
Camera features include:
650 TV-line resolution in color, 720 TVL B / W
•
Advanced Gen V DSP
•
Smart DNR technology efficiently reduces noise
•
in low light conditions
75 foot range with Smart IR 24-LED IR LED array
•
3-axis camera gimbal - mountable on ceiling,
•
wall or sloped surface
Day & Night function (ICR)
•
Support up to 8 privacy zones
•
Digital Wide Dynamic Range (DWDR)
•
Multi function : High Light Mask, Lens Shading
•
Compensation, Smart Motion Detection
Smart IR technology greatly improves camera
•
image in B / W mode when the IR LED array is on
Multi-language full OSD support
•
Precautions
Do not install the camera outdoors.
•
Do not install the camera in locations subject to moisture or vibration.
•
Do not scratch the camera, especially lens or dome cover.
•
Operate the camera within the specified temperature range 14 °F ~ 122 °F (-10 °C ~ 50 °C).
•
Handle with care. Dropping it can cause serious damage to the camera.
•
Do not install the camera in locations where direct sunlight shines onto or be reflected onto the lens.
•
Use a 12 Vdc, 1A regulated power adapter, or 24 Vac power adaptor.
•
Installation
1. Remove the camera dome by pressing on the PUSH marks, then lifting the dome off the base. See
below. Do not remove the protective sheet at this time.
1
PUSH
2. Using the base assembly as a template, mark the locations for the mounting screws (2) and the hole
for the drop cable on the mounting surface. Note that the drop cable can be routed through a cable
channel in the base and exit on the side of the camera assembly. The camera can be mounted on a
ceiling or wall.
Screw
Dome
Camera
module
3. Select the best fasteners to secure the camera to the surface on which it will to be mounted. Screws
provided with the camera are adequate many surface types.
4. Drill holes in the mounting surface as required for the mounting screws (wall inserts, etc.), and the
Base
drop cable, if needed.
Seal
5. Carefully route the camera drop cable through the drop cable hole or the cable channel in the base,
then attach the camera to the mounting surface.
Drop
cable
6. Route a video / power extension cable between your monitoring equipment and the camera. Note
that the extension cable connectors are usually different at each end.
7. Connect the video / power extension cable to your camera, then connect the other end to a video
monitor and 12 Vdc or 24 Vac power source. NOTE: 1) The camera power cable provides a 2-pin
connector; an adapter with screw-down terminals is included in the box. 2) If powering the camera
with 12 Vdc, observe the polarity marked on the power drop cable.
8. Verify that you can see video from your camera at the monitoring equipment.
NOTE: An external video connector is provided on the camera module. See "Maintenance board"
on page 2. The adapter cable provided with your camera offers composite video through an RCA
connector to a local monitor.
Protective Sheet
PUSH
Hole for
drop cable
Video drop cable
Power drop cable
12 Vdc polarity guide
Terminal adapter
BLK-CPD207VH_CQ
9/26/12