Remote Punch Bass; Operation; Adjusting Gain; Adjusting Crossover Frequency - Rockford Fosgate Mono Amplifiers Installation & Operation Manual

I
NSTALLATION

REMOTE PUNCH BASS

Mounting and installation
1. Find a location, either under the dash or
near the center console, that gives easy
access to the remote.
2. Using the screws supplied, install the
mounting clip with the tabs towards t
he back.
3. Route the cable for the remote and
connect to both the remote and
amplifed subwoofer.
4. Slip the remote onto the mounting clip
until it snaps into place.
5. Install the decal and knob onto the
remote.
O
PERATION

ADJUSTING GAIN

To adjust the gain setting, turn the amplifier gains all the way down. Turn the source unit volume up
until distortion is audible and then turn it down a bit until the distortion is inaudible. This will be
about two thirds all the way up on most source units. Next, turn the amplifier gain setting until once
again distortion is audible and then back it down until the distortion is inaudible. Rockford Fosgate
source units do not distort, so the volume can be used at maximum setting.
NOTE: For a more in depth setting procedure, contact Rockford Technical Support.

ADJUSTING CROSSOVER FREQUENCY

The crossover frequency can be adjusted between 50-250Hz. The crossover is set to LP (Low Pass)
operation only.
Turn the crossover adjustment knob all the way down. With the system playing, turn the crossover
adjustment knob up slowly until the desired crossover point is achieved.
SUBSONIC FILTER
Placing the switch to "ON" engages a subsonic filter limiting the amount of low frequency
information going to the woofer. Set this to your personal preference while listening to the system
one way, then the other.
8
Mounting
Clip
Knob
Decal