Table of Contents
Advertisement
TEMPERATURE
SENSOR
1. Connect any interface module(s) to the
data port(s) and set for data mode.
2. Turn the ignition key ON
3. Activate remote start
System will chirp/flash lights to indicate engine
type (Default: 1x = Gasoline)
4. Press valet to change engine type:
1 chirp=Gasoline, 2 chirps=Diesel 15,
3 chirps=Diesel 20, 4 chirps=Diesel 30
5. Start the engine with the ignition key
6. Turn the ignition key OFF
System will chirp/flash lights equaling the # of
IGN/ACC/START circuits detected (Max: 4x)
VEHICLE LEARN PROCEDURE
7. Within 20 seconds of Step 6, Activate
(do not start)
8. OPTIONAL: To enable Manual
9. TO SAVE SETTINGS: Shut down RS by
4 PIN DOOR LOCK PORT
Lock (-) Out - GREEN
Constant 12v (+) Out - PIN
Unlock (-) Out - BLUE
WINDOW-MOUNT ANTENNA MODULE
Valet / Programming
Button
3 PIN SAT. RELAY PORT (RED)
3
Start
(-) Out - GREEN
Constant 12v (+) Out - RED
3
Status
(-) Out - BLUE
GREEN INTERFACE
MODULE DATA PORT
BLACK INTERFACE
MODULE DATA PORT
remote start. Wait until engine is running
and LED is flashing slow.
Transmission Reservation mode, release
and set parking brake again.
System should chirp/flash lights 1x.
pressing the BRAKE pedal.
TO CANCEL/START OVER: Shut down
RS by remote or input wire.
~ See Page 10 For Full Details ~
Status Light
7
Hide quick links:
Advertisement
Table of Contents
