Table of Contents
Advertisement
6 Pin Main Wire Harness (cont'd)
ORANGE WIRE -
This circuit is designed to power additional IGNITION, ACCESSORY, or START
circuits. By default, it functions as an ACCESSORY output & turns on when remote
start is activated (slightly earlier than the ignition output), turns off during engine
cranking, & turns back on for the remainder of the remote start operation.
CONNECTION: Use any IGNITION, ACCESSORY, or secondary START circuit in
the vehicle. This wire is defaulted for ACCESSORY output though it may change
through the VEHICLE LEARN process (p.10) to match the connected vehicle circuit.
VIOLET WIRE - START (+) INPUT/OUTPUT
This output supplies positive voltage to the vehicle's starter circuit. If using an
anti-grind, be sure this is connected on the starter side of the interrupt.
CONNECTION: The starter circuit is typically found at the ignition switch. The proper
circuit will show +12v only when the ignition key is in the START position.
PINK/WHITE WIRE -
This circuit is designed to power additional IGNITION, ACCESSORY, or START
circuits. By default, it functions as an IGNITION output. It turns on when remote start
is activated, stays on during engine cranking, & for the entire remote start operation.
CONNECTION: Use any IGNITION, ACCESSORY, or secondary START circuit
in the vehicle. This wire is defaulted for IGNITION output though it may change
through the VEHICLE LEARN process (p.10) to match the connected vehicle circuit.
14 Pin Secondary Wire Harness
BLACK WIRE - SYSTEM GROUND (-) INPUT
REQUIRED. This input provides negative ground for all system operations.
CONNECTION: Using a properly sized ring terminal, connect this wire to the ve-
hicle's chassis. Using an existing bolt is preferred but make sure that the connection
point is clean and free of dirt, grease, or paint. Bright shiny metal at the connection
point is desired.
ORANGE WIRE - STATUS/ANTI-GRIND (-) OUTPUT
This provides 500mA negative ground while the alarm is armed and/or during
remote start for anti-grind operation. The operation is selectable with installer feature
#16.
CONNECTION: This wire is connected to the orange input wire on an optional start
interrupt relay.
BROWN/RED WIRE - BRAKE PEDAL (+) INPUT
REQUIRED. This input is a critical safety circuit which disables the remote start
operation whenever the brake pedal is pressed.
CONNECTION: Connect this to the brake switch wire that shows +12 volts when the
brake pedal is pressed.
4
ACCESSORY/IGN/START
IGNITION/ACC/START
(+) IN/OUT
(+) IN/OUT
Hide quick links:
Advertisement
Table of Contents
