Functional Description - Makita GD0801C Instruction Manual

Additional Safety Warnings:
21. The tool is intended for use with bonded
abrasive wheel
permanently mounted on plain, unthreaded
mandrel (shanks).
22. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
23. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced wheel.
24. Use the specified surface of the wheel to
perform the grinding.
25. Watch out for flying sparks. Hold the tool so
that sparks fly away from you and other
persons or flammable materials.
26. Do not leave the tool running. Operate the tool
only when hand-held.
27. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
28. Observe the instructions of the manufacturer
for correct mounting and use of wheels.
Handle and store wheels with care.
29. Check that
supported.
30. If working place is extremely hot and humid,
or badly polluted by conductive dust, use a
short-circuit breaker (30 mA) to assure
operator safety.
31. Do not use the tool on any materials
containing asbestos.
32. Always be sure you have a firm footing. Be
sure no one is below when using the tool in
high locations.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
points (grinding
the workpiece is

FUNCTIONAL DESCRIPTION

stones)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch lever actuates properly and returns
to the "OFF" position when released.
Do not pull the switch lever forcibly without pulling
•
in the lock-off lever. This may cause switch
breakage.
properly
015004
To prevent the switch lever from accidentally pulled, a
lock-off lever is provided.
015009
To start the tool, pull the lock-off lever toward the
operator and then pull the switch lever. Release the
switch lever to stop.
Speed adjusting dial
015005
The tool speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 5.
6
1
2
1
1
1. Lock-off lever
1. Lock-off lever
2. Switch lever
1. Speed adjusting
dial