Arrow Revolution Installation And Programming Instructions page 6

5. Secure both assemblies using (2) M6 x 59.5mm pan
head machine screws, making sure that outside
escutcheon is vertically aligned.
Tighten securely with a #2 Phillips screwdriver.
Do not over-tighten.
6. Attach cable assembly to the inside escutcheon
printed circuit board (PCB) by lining up notches on
top of cable connector to slots on PCB connector
(Fig. 6A). Press connector in firmly using thumbs
until completely seated (proper position indicated
by arrows on PCB as in Figures 6A and 6B) .
CAUTION:
Use care when assembling to ensure that
the cable lies against the back recessed
area of the inside escutcheon (Fig. 6A).
Position and bend cable to prevent binding
when installing the escutcheon over the
mounting plate.
Figure 6B
7. Install inside escutcheon on inside mounting plate.
Note in Fig. 7A the horizontal orientation of the tail
piece as you insert the inside escutcheon (thumb
turn should be vertical).
8. Install and secure using (3) M4 x 8mm pan head
screws through the inside escutcheon into
the mounting plate.
IMPORTANT: Before installing the batteries, test
the mechanical operation of the lock by using
both thumb turn and the key. The movement of the
bolt should be smooth and unobstructed. If
operation is not smooth, review the previous steps
to ensure proper installation.
9. Insert four (4) AA alkaline batteries. Lock responds,
"Welcome to the Arrow Revolution" and will
adjust for proper handing of the lock.
Note: Refer to programming instructions prior to
completion of step 10.
10. Install battery cover and tighten Phillips
head screw.
Harness
clip
Figure 6A
Figure 7A
P/N LT-503200 Rev A
6