Table of Contents
Advertisement
Symantec Upgrade Installation Guide
Install the ASG-S400 Memory Modules
When upgrading your ASG-S400 appliance, review the appliance memory configuration of the target specification and the
DIMM slot usage for each memory module. DIMMs are grouped by channels and are marked on the motherboard (ex.
slots A1, A2, B1, etc). Moreover, memory upgrades replace all existing memory in the appliance. Take care not to mix the
upgrade memory and existing system memory modules!
The memory configuration details are shown below:
ASG-S400
Memory Slot
Upgrade Kit
Usage
ASG-S400-20 to
48GB total
ASG-S400-30
memory: (8GB x
6) - A1, A2, B1,
B2, C1, C2
72GB total
ASG-S400-30
memory: (16GB x
to ASG-S400-
3) - A1, B1, C1;
40
(8GB x 3) - A2,
B2, C2
Review the "Safety Warnings and Cautions" on page 31 before servicing your appliance. ALWAYS observe proper
electrostatic discharge (ESD) conventions. Attach an ESD protective wrist strap to your wrist and to the chassis.
Ensure that the appliance is on an ESD-safe work surface or ground the unit appropriately. Symantec does not
assume responsibility or liability for damage resulting from ESD.
Notes:
Memory upgrades replace all existing memory in the appliance. Take care not to mix the upgrade memory and
l
existing system memory modules!
Do not install any DIMMs which are not explicitly supported by the appliance. Installation and use of unauthorized
l
DIMMs might damage the appliance and will invalidate your Symantec service contract!
1. Remove all of the existing memory (do not mix existing DIMMs with the included replacement DIMMs). Depress
both of the locking latches per slot (a) to release the DIMM and remove it from the DIMM slot (b).
Reference Image
15
Hide quick links:
Advertisement
Table of Contents
