Siemens SIROTEC Planning Manual page 4

Identification of the documentation
Printing history
Brief details of this edition and previous editions are listed below.
The status of each edition is shown by the code in the "Remarks" columns.
Status code in the "Remarks" column:
A .... New documentation.
B .... Unrevised reprint with new order no.
C .... Revised edition with new status.
Edition Order No.
12.98 6FC5297-0AD30-0BP0
06.99 6FC5297-0AD30-0BP1
03.04 6FC5297-0AD30-0BP2
This book is part of the documentation on CD-ROM (DOCONCD)
Edition Order No.
03.04 6FC5298-7CA00-0BG0
Trademarks
SIMATIC®, SIMATIC HMI®, SIMATIC NET®, SIROTEC®, SINUMERIK® and SIMODRIVE® are registered
trademarks of Siemens AG. IBM® is a registered trademark of International Business Corporation. MS-DOS® and
TM
WINDOWS are registered trademarks of Microsoft Corporation. Other product names used in this
documentation may be trademarks which, if used by third parties, could infringe the rights of their owners.
Further information is available on the Internet under:
http://www.siemens.com/motioncontrol
This publicatio was produced with WinWord V 8.0 and Designer V 7.0
and the DocuTool AutWinDoc.
The reproduction, transmission, or use of this document or its contents
is not permitted without express written authority. Offenders will be
liable for damages. All rights, including those created by patent grant or
registration or a utility model or design, are reserved.
© Siemens AG, 2004. All rights reserved
Order No. 6FC5297-0AD30-0BP2
Printed in Germany
Remarks
A
C
C
Remarks
C
We have checked that the contents of this document corresponds to
the hardware and software described. Nonetheless, differences might
exist and therefore we cannot guarantee that they are completely
identical. The information contained in this documentation is, however,
reviewed regularly and any necessary changes will be included in the
next edition. We welcome suggestions for improvement.
Subject to change without prior notice
Siemens Aktiengesellschaft