Stylus Input Not Working; The Tablet Pc Does Not Start After Switch On; The Tablet Pc Stops Working; The Printer Does Not Print - Fujitsu STYLISTIC Q508 Manual

Stylus input not working

Cause
Incorrect driver installed.

The Tablet PC does not start after switch on

TabletPC
Cause
The battery is dead.
The AC adapter is not connected properly.

The Tablet PC stops working

TabletPC Ending
Cause
The Tablet PC is in energy saving mode.
An application program has caused the
malfunction.
The battery is dead.

The printer does not print

Printer doesnotprint
Cause
The printer is not switched on.
The printer is not connected correctly.
The printer driver is faulty or not correctly
installed, or it is the wrong printer driver.
Fujitsu
Troubleshooting
► Reinstall the driver for the "dual digitizer".
Troubleshooting
► Charge the battery.
or
► Connect the AC adapter to the Tablet
PC.
► Check whether the AC adapter is properly
connected to the Tablet PC.
► Switch the Tablet PC on.
Troubleshooting
► End energy saving mode.
► Close the application program or restart
the Tablet PC (by restarting the operating
system or switching the device off and back
on again).
► Charge the battery.
or
► Connect the AC adapter to the Tablet
PC.
Troubleshooting
► Make sure that the printer is switched
on and ready for operation (refer to the
documentation supplied with the printer).
► Check that the data cable between the Tablet
PC and the printer is properly connected.
► Check that the data cable between the Tablet
PC and the printer is properly connected.
► Check whether the correct printer driver is
loaded (refer to the printer documentation).
Troubleshooting and tips
79