The cursor does not correctly follow the
stylus movements
Cause
Stylus incorrectly calibrated.
Stylus input not working
Cause
Incorrect driver installed.
The Tablet PC does not start after switch on
Cause
TabletPC
The battery is dead.
The AC adapter is not connected properly.
The Tablet PC stops working
Cause
TabletPC
Ending
The Tablet PC is in energy saving mode.
An application program has caused the
malfunction.
The battery is dead.
Fujitsu
Troubleshooting
► Calibrate the stylus as described in chapters
"Adjusting the stylus", Page 29
"Calibrating the stylus", Page
Troubleshooting
► Reinstall the driver for the "dual digitizer".
Troubleshooting
► Charge the battery.
or
► Connect the AC adapter to the Tablet
PC.
► Check whether the AC adapter is properly
connected to the Tablet PC.
► Switch the Tablet PC on.
Troubleshooting
► End energy saving mode.
► Close the application program or restart
the Tablet PC (by restarting the operating
system or switching the device off and back
on again).
► Charge the battery.
or
► Connect the AC adapter to the Tablet
PC.
Troubleshooting and tips
and
30.
71