Operation - ElectrIQ EDD8L User Manual

OPERATION

Before operating the unit, please ensure it is plugged into a mains socket, and open the air deflector on
the top of the unit.
Switching the unit ON and OFF
Press the power button to turn on the unit. The unit will start to work in sleep mode, with a desired
humidity of 50% set. To turn off the unit press the power button again.
Please note that when turning it off, the dehumidifier will still operate for a number of minutes to
discharge the remaining water from the desiccant disk and prevent mould growth.
Setting the Laundry Mode
Press the Laundry
humidistat control will be disabled.
Setting the Timer
On pressing the timer key
hours after which the dehumidifier will stop. The displayed time will revert to humidity display a
number of seconds after selection was made.
When selecting '4 hours' for example the unit will stop operating after 4 hours at the selected
humidity / fan settings. If the tank becomes full before the finish time, the unit will stop, and the
Tank Full LED will flash.
At any point the timer key can be pressed repeatedly to change the desired duration or until 00 is
displayed to cancel the timer.
If the timer button is used while the unit is turned off (But Plugged in), you can specify the number of
hours until the unit turns on.
Button . Laundry mode will set the fan and heater on to maximum and
the 2 digits LED display will cycle through 1 24 showing the number
Do not dry laundry above the unit to
prevent water entering the dehumidifier.
Place the laundry at least 40 cm away from
your dehumidifier. Direct the unit with
front vents towards the clothes airer or
hanging clothes. Hot dry air comes from a
45 degrees angle. Laundry mode can be
used in conjunction with the stopping
timer.
IMPORTANT: Please follow the distances
shown on the diagram, to ensure that the
walls, clothing, and other objects are kept a
safe distance from the unit.
9