Operational Advice - ElectrIQ EDD8L User Manual

Setting the Dehumidification level
Start the unit and leave it for 5 10 minutes on sleep mode (50%RH) until the humidistat is able to
correctly read the humidity within the room.
Press the humidity level key
operation (CO) to 40% 50% 60% 70%.
While pressing the humidity level key the display cycles the humidistat set range for this unit from 40%
through 50% 60% 70%
Intelligent dehumidification and power saving
Your ElectrIQ dehumidifier features an intelligent micro CPU that ensure maximum water extraction
with minimum power use for the selection made.
The unit will try to maintain humidity level selected in the room by turning off the heating element
when the desired humidity is reached. Note that according to the space where the unit is used,
obstacles in the direct flow, extra humidity being added at any time, settings selected, as well as other
environmental factors the results may vary.

OPERATIONAL ADVICE

Plug to power, press the power button to turn on the machine; press the power button again to
1.
turn off the dehumidifier.
Make sure water tank is placed/ fitted correctly. If the water tank is not fitted/placed correctly the
2.
'water full' light
When the dehumidifier first starts, default humidity setting is set to 50% RH.
3.
When unplugging from the wall socket use one hand to hold the plug and the other hand against
4.
socket to avoid power cord damage.
WARNING: Using poor quality sockets, extensions or overloading the circuits may cause damage to
the machine or may start a fire.
When switching OFF the machine, do not simply unplug the unit from the socket ensure you turn
5.
off the machine properly and have allowed it to complete the drying cycle ( wait for the fan to stop),
before unplugging.
Tilt Protection
Your ElectrIQ dehumidifier was designed with safety in mind. When unit is tilted it will be shut down to
minimize safety risk or damage. The On light will flash red, to indicate anti tilt protection has activated.
If the unit has been tilted, please do not use if for a day or two until the internals are completely dried, as
using the unit after it has been tilted could result in a short circuit, which would internally damage the unit.
Consult the service centre if in any doubts
to select the desired humidistat controls from continuous
back to continuous mode.
will flash and the machine will not operate.
10