Mitsubishi SD200U Service Manual page 72

Removal of Lamp
Note: Only service persons are allowed to replace the
Lamp.
Be careful not to scratch or leave a fingerprint on the
Lamp when replacing it.
(Removal)
1. Remove the (a) screw and the Power Socket as shown
in Fig. 4-1.
2. Unfasten the two (b) catches and the Lamp Support
(U) as shown in Fig. 4-1.
3. Remove Lamp as shown in Fig. 4-2.
(Installation)
1. Make sure that the Lamp Support (D) and the Lamp
Support (S) shown in Fig. 4-3 are attached securely.
2. Install the Lamp in reverse order of the removal
procedure.
Power Socket
a x1
Lamp Support (D)
- 14 -
Lamp Support (U)
b x2
Fig. 4-1
Lamp
Fig. 4-2
Lamp Support (S)
Fig. 4-3