Mitsubishi SD200U Service Manual page 66

DISASSEMBLY
1. Removal of FRONT GRILL
1. Remove the (a) screw as shown in Fig. 3-1.
2. Remove the Front Grill as shown in Fig. 3-1.
2. Removal of TOP CASE ASSY
1. Remove the Front Grill following "1. Removal of FRONT
GRILL".
2. Remove the six (b) screws as shown in Fig. 3-1.
3. Remove the Top Case Assy as shown in Fig. 3-1.
Note: Also remove the CR connector on the IRR PCB
ASSY, the KT connector on the KEY PCB ASSY
when removing the Top Case Assy.
3. Removal of SIGNAL PCB ASSY and
FORMATTER PCB ASSY
1. Remove the Front Grill following "1. Removal of FRONT
GRILL".
2. Remove the Top Case Assy following "2. Removal of
TOP CASE ASSY".
3. Remove the two (a) screws, the three (b) screws and
the SIGNAL PCB ASSY as shown in Fig. 3-2.
4. Remove the four (C) screws and the FORMATTER
PCB ASSY as shown in Fig. 3-2.
Top Case Assy
bx1
SIGNAL PCB ASSY
a x2
SIGNAL B Holder
- 8 -
bx3
b x1
b
x1
ax1
Front Grill
Fig. 3-1
b x3
SIGNAL
A Holder
FORMATTER
PCB ASSY
c x4
Fig. 3-2