Table of Contents
Advertisement
4. Removal of POWER PCB ASSY,
TERMINAL PCB ASSY and PFC PCB
ASSY
1. Remove the Front Grill following "1. Removal of FRONT
GRILL".
2. Remove the Top Case Assy following "2. Removal of
TOP CASE ASSY".
3. Remove the SIGNAL PCB ASSY and FORMATTER
PCB ASSY following "3. Removal of SIGNAL PCB
ASSY and FORMATTER PCB ASSY".
4. Remove the (a) screw and the Terminal Board as
shown in Fig. 3-3-1.
5. Remove the three (b) screws and the Power Assy as
shown in Fig. 3-3-1.
6. Remove the (c) screw and the earth wire from the
POWER PCB ASSY as shown in Fig. 3-3-2.
7. Remove the two (d) screws and the POWER PCB
ASSY as shown in Fig. 3-3-2.
8. Unfasten the (e) catch and the POWER PCB ASSY as
shown in Fig. 3-3-2.
9. Disconnect the Connector PA and the PFC PCB ASSY
as shown in Fig. 3-3-2.
10. Remove the four (f) screws, the six (g) screws and
the TERMINAL PCB ASSY as shown in Fig. 3-3-2.
b x3
ax1
Terminal Board
Power Frame Assy
POWER PCB ASSY
d x2
Terminal Plate
f x4
c x1
earth wire from the
POWER PCB ASSY
- 9 -
Power Assy
Fig. 3-3-1
e x1
Connctor PA
PFC PCB ASSY
TERMINAL
PCB ASSY
gx6
Fig. 3-3-2
Advertisement
Table of Contents
