Subaru Forester 2001 Service Manual page 6

4) Remove the two bolts which hold the washer
tank, then take the tank away from the working
area.
5) Disconnect connector from ignition coil.
6) Remove ignition coil.
7) Remove spark plug with the spark plugs socket.
SPARK PLUG
B: INSTALLATION
1. RH SIDE
1) Install in the reverse order of removal.
Tightening torque (Spark plug):
21 N·m (2.1 kgf-m, 15 ft-lb)
Tightening torque (Ignition coil):
16 N·m (1.63 kgf-m, 11.8 ft-lb)
CAUTION:
The above torque should be only applied to
new spark plugs without oil on their threads.
In case their threads are lubricated, the torque
should be reduced by approximately 1/3 of the
B2M2023
specified torque in order to avoid over-stress-
ing.
2. LH SIDE
1) Install in the reverse order of removal.
Tightening torque (Spark plug):
21 N·m (2.1 kgf-m, 15 ft-lb)
Tightening torque (Ignition coil):
16 N·m (1.63 kgf-m, 11.8 ft-lb)
CAUTION:
The above torque should be only applied to
new spark plugs without oil on their threads.
EN0857
In case their threads are lubricated, the torque
should be reduced by approximately 1/3 of the
specified torque in order to avoid over-stress-
ing.
EN0858
EN0859
IG(DOHC TURBO)-5
S181003A11
S181003A1101
S181003A1102
Ignition