Grounding; Wiring Check - Furuno DS-80 Installation Manual

2.7

Grounding

This equipment uses pulse signals which may cause interference to other electronic equipment.
It is strongly recommended to ground all cables referring to the guidelines below.
•
Separate all units as far as possible from radio equipment.
•
Do not run interconnection cables close to or near radio equipment or its cables.
•
Run the cables in the shortest path practical.
•
Ground all units with a copper strap or earth wire.
•
To joint copper straps, use solder cream for perfect contact.
2.8

Wiring Check

After the all wiring, make sure the toggle switches are set as below in the transceiver unit and
distribution box.
Tx toggle switch:
Upper
Power switch:
Upper (ON)
Transceiver unit DS-810,
inside arrangment
S1
ON
OFF
Board power switch: Set to OFF.
ON
OFF
Power switch: Upper (ON)
Distribution box DS-801,
inside arrangement
25