Section 5: Communications; Dedicated Phone Line For Central Controller Modem; Figure 13: Modem Location - Roberts Gorden UltraVac NEMA 4 Installation Manual

ROBERTS GORDON ® ULTRAVAC™ C

SECTION 5: COMMUNICATIONS

One ROBERTS GORDON
per building (called the "central controller) must have
equipment for remote communications to a PC. This
equipment consists of either a modem chip, an RS-
485 converter, or a TCP/IP communications module.
For remote on-site and off-site control and system
status viewing the central controller (controller
fitted with a modem chip. See Page 20, Section 5.1.
If only remote on-site control and system status
viewing, two controller communications interface
devices are available: an RS-485 converter or a
TCP/IP communication module.
An RS-485 converter is installed at a single PC, this
PC can interface with any controller on the network
of ULTRAVAC™ controllers. The RS-485 converter at
the PC is wired directly to controller #1 using

FIGURE 13: Modem Location

Control Board of the
Central Controller
NC C NO NC C NO NC C NO NC C NO
NC C NO NC C NO NC C NO NC C NO
Description Part Number
Modem Chip 10080142
5.1 Dedicated Phone Line for Central Controller
Modem
The Central Controller is fitted with a modem chip. To
use the modem, the controller must have a phone
line for modem communications. Install a phone line
near the location of the Central Controller. The phone
cable is plugged into the phone connection in the
corner of the control board. See Page 20, Figure 13.
If the modem option is not used for everyday commu-
nication to the controller(s), it can still be plugged into
a phone line for troubleshooting or programming
assistance. Contact your local Roberts-Gordon inde-
pendent distributor for details.
20
I M
ONTROLLER NSTALLATION ANUAL
® ULTRAVAC™ Controller
L1 PWR - + -
L2 OUT IN G +32 +5 G G G REF REF
OUT IN
24VAC
RS232 DIRECT
AUX POWER RS485 COMM
UNIVERSAL INPUTS
8 7 6 5 4 3 2 1
- + - + - + - + - + - + - + - +
Phone Cable Connection
shielded twisted pair communication wiring.
See Page 21, Figure 14.
To interface with ULTRAVAC™ controllers through a
Local Area Network (LAN), a TCP/IP Communication
module is installed at controller #1. Controller #1 is
wired to the LAN by an Ethernet cable. See Page 22,
Section 5.3. Any computer on the LAN that has
# 1) is
ULTRAVAC™ software installed can communicate
with the controllers. Appropriate precautions must be
taken to protect the Ethernet wiring from any possible
electrical interference (noise) caused by surrounding
machinery or equipment.
If multiple ULTRAVAC™ controllers are being used,
the additional controllers communicate to controller
#1 through communication wiring arranged in-series
from one controller to the next. See Page 25, Section
5.5.
1 2 3 4 5 6 7 8
+ - + - + - + - +
4 3 2 1
METER INPUTS
RESET
OH CD RI
ADDRESS
CPU
OUT
499 OHM
IN
OFF
10VDC
ON
If multiple ULTRAVAC™ controllers are being used, the
additional controllers communicate to controller #1
through RS-485 communication wiring arranged
in-series from one controller to the next. See Page 25,
Section 5.5. This allows multiple controllers to be
controlled from a PC through a single communication
package at the central controller.
#
Dip Switch 1
Set to ON
Modem
Chip
Installed
Modem Chip