Remove The Old Unit - Virtual Reality Multi-Media Headunit VRVD630 Owner's Manual

Installation
1. Remove the Old Unit from the Dashboard
A. Remove the outer trim frame.
DIN Front Mount
2. Mark Polarity of the Speaker Wires
Marking the polarity of the speaker
wires will make it easier to connect
the existing speakers to the VRVD60.
Consult the wiring diagram of the exist-
ing head unit before disconnecting any
wires. If a wiring diagram is not available
contact the head unit's manufacturer.
. While the old unit is playing, discon-
nect the wires from one speaker.
2. Take a length of masking tape and
fold it around the wire so it forms a
flag.
B. Insert the buttons supplied with the old
unit into both sides of the unit as shown
in figure below until they click. Pull to re-
move the old unit from the dashboard.
DO NOT DISCONNECT WIRES AT THIS TIME!
. On the masking tape mark the polar-
4. Double check that you marked the
5. Repeat this procedure for all of the
6. Mark the power, ground, and any
GIVE US A CALL, WE'LL HELP YOU INSTALL.
PLEASE DO NOT RETURN PRODUCT TO STORE.
www.vr-3.com
For Information and Technical Assistance,
Call Toll-Free in U.S.A. and Canada.
1-800-445-1797
8
ity of the speaker wires (+ & - ), as
well as left or right, and front or rear.
first speaker correctly by checking
that the speaker wires are the same
at the head unit.
speakers.
other wires also.
Visit us on the WEB