TSC TTP-225 Series Quick Installation Manual

Quick Installation Guide
Printer Overview
Media view window
LED indicator
Feed button
Paper exit chute
Top cover
open lever
Note:
The interface picture in the quick start guide is for reference only. Please refer to the product specification for the
interfaces availability.
Media holder
lock switch
Gap sensor
(Transmitter)
Media guide
adjuster knob
Black mark sensor
Platen roller
Power
switch
SD card socket
Power jack
RS-232C interface
USB
socket
interface
Ribbon access cover
Ribbon rewind hub
Ribbon rewind gear
Ribbon supply hub
Gap sensor (Receiver)
Media holders
Media guides
Open / Close the Top Cover
(1) Open the printer top cover by pulling
the tabs located on each side
towards the front of the printer, then
lift the top cover to the maximum
open angle.
Loading the Ribbon
(1) Open the printer's top cover by
Print head
pulling the top cover open levers
located on each side of the printer
and lifting the top cover to the
maximum open angle.
Top cover
Top cover
support
(4) Stick the ribbon onto the ribbon
rewind paper core and insert the
paper core onto the rewind hub.
Page 1 of 2
(2) A top cover support at the rear of (3) Hold the top cover and press the top
the printer will engage with lower cover support to disengage the top
inner cover to hold the printer top cover support with lower inner cover.
cover open. Gently close the top cover.
(2) Open the ribbon access cover. (3) Insert the ribbon right side onto the
supply hub. Align the notches on the
left side and mount onto the spokes.
* Loading Path for Ribbon
(5) Turn the ribbon rewind gear until the
ribbon plastic leader is thoroughly
wound and the black section of the
ribbon covers the print head. Close
the ribbon access cover and the top
cover.