Mounting The Tdl; Mounting With Screws; Mounting With Adhesive Tape - Bosch TDL 110 Operating Instructions Manual

Transport Data Logger TDL 110

5 Mounting the TDL

The TDL comes with an integrated mounting plate at the bottom side. The mounting plate provides
four mounting holes for screw fastening purposes.
3
Figure 2 Mounting the TDL using screws
1 Screwdriver
2 Screw
3 Mounting holes
In general, the TDL can be mounted in any position as required. The fastening, depending on the
specific requirements, can be carried out with screws or with double-sided adhesive tape.
In case shock shall be measured a direct and non-absorbing connection between the TDL and
the monitored good is required. For achieving this we recommend using either screws or a fiber-
reinforced adhesive tape.

5.1 Mounting with Screws

Recommended screws:
M5 or M4 (recommended with washer) raised cheese head / pan head / round head screws.
Recommended tightening torque: 1 Nm

5.2 Mounting with Adhesive Tape

Tape specifications: Double-sided fiber-reinforced adhesive tape (tested with Tesa 56172-00003)
BCDS-TDL110/0001 (2017-09)
1
2
3
7 | 20