Regulatory Notices; Recycling; Eu Declaration Of Conformity; Federal Communications - Bosch TDL 110 Operating Instructions Manual

Transport Data Logger TDL 110

8 Regulatory Notices

8.1 Recycling

Disposal according to the WEEE Directive 2012/19/EU
The unit, accessories and packaging should be sorted for environmental friendly
recycling. Do not dispose of the device into household waste! According to the
European Guideline 2012/19/EU, electric and electronic devices that are no longer
usable must be collected separately and disposed of in an environmentally correct
manner.
For disposal in countries outside of the European Union
This symbol is only valid in the European Union (EU). If you wish to discard this product please
contact your local authorities or dealer and ask for the correct method of disposal.

8.2 EU Declaration of Conformity

Hereby, Bosch Connected Devices and Solutions GmbH declares that the radio
equipment type Transport Data Logger TDL 110 is in compliance with Directive
2014/53/EU (Radio Equipment Directive).
Radio power max. 4 mW
►
Frequency band 2400 – 2483.5 MHz
►
The full text of the EU declaration of conformity is available at the following
internet address: www.bosch-connectivity.com/TDL110
8.3 Federal Communications Commission (FCC) Notice
FCC has issued an EQUIPMENT AUTHORIZATION to Bosch Connected Devices and Solutions
GmbH for XDK110 according to FCC rule parts 15 C with the FCC ID: 2ADSJTDL110
The manufacturer is not responsible for any changes or modifications not expressly approved
by the party responsible for compliance. Such modifications may void the FCC authorization to
operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
►
Increase the separation between the equipment and receiver.
►
Connect the equipment into an outlet on a circuit different from that
►
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
►
BCDS-TDL110/0001 (2017-09)
17 | 20