Introduction And Intended Use; Intended Use - Bosch TDL 110 Operating Instructions Manual

4 | 20

2 Introduction and Intended Use

By being attached to the shipment and measuring and recording relevant parameters like
temperature, humidity, tilt and shock, the TDL makes the delivery process of goods visible and
traceable. These measurements are then documented and visualized through a mobile application.
Since the limits of each parameter can be individually configured, any violation of these limits is
traceable and clearly assignable to the stations throughout the entire transport process.

2.1 Intended Use

The Transport Data Logger is designed according to the information provided in the data sheet.
Any use or operation which requires specific requirements and standards which aren't explicitly
mentioned in the data sheet must be validated and tested on customer's own responsibility.
6
5
Figure 1 Overview TDL
1 Surface: place your shipment code here (see INFO below).
2 Button (see chapter 5 Operation)
3 LED (green/red) (see Blinking Patterns on page 15)
4 Mounting holes (4x) (see Mounting the TDL on page 7)
5 Battery (see Changing the Battery on page 16)
6 Mounting plate (see Mounting the TDL on page 7)
INFO
Consider that the humidity sensor should not be covered by labels or stickers. Otherwise
the humidity measurement doesn't work.
For further assistance please refer to:
http://www.bosch-connectivity.com/TDL110 or e-mail to: support@bosch-connectivity.com
TDL 110 Transport Data Logger
1
2
3
4
BCDS-TDL110/0001 (2017-09)