Advertisement
Assembly and Installation (Continued)
Electric Cable Connection
Red Positive Cable
(To Positive Terminal on Battery)
Attach red, yellow and green short cables
to motor terminals as shown. Note: The
three copper terminal stud ends are color
coded. Tighten all three brass nuts onto
terminals using a 13mm wrench.
DO NOT OVER TIGHTEN.
Fire/Electrical Spark/Chemical Burn Hazards:
Connecting winch to battery and winch operation may cause
electrical arcs. Never install or use winch where gasoline leaks,
vapors or other flammables are present.
Always wear eye protection & remove jewelry when working with
battery or installing winch electrical cables. Plan connections to
avoid fuel lines, hot or rotating parts. Never route electrical cable
or winch controller across sharp edges, doors or other pinch
points.
Always use supplied terminal boots, insulate any other exposed
connections neatly support all wiring. Depending on your level of
knowledge regarding electrical wiring, you may wish to have this
procedure performed by a qualified technician.
Attach black ground cable to motor
terminal and black thermo relay wire
with brass bolt. Tighten brass bolt onto
terminal using a 14mm wrench.
DO NOT OVER TIGHTEN.
The Trusted Source
5
Yellow Motor Stator Cable
Green Motor Stator Cable
Red Motor Rotator Cable
Black Thermo Relay Wire
Black Negative Ground Cable
Black Negative Ground Cable
(To Negative Terminal on Battery)
®
Advertisement
