Advertisement
Assembly and Installation:
Attach the solenoid pack to the side mount
solenoid bracket using a flat washer, split
lock washer and nut for each
of the four studs. Tighten
using a 10mm wrench.
Solenoid Installation (as Side Mount)
Photo A. Carefully study the relation-
ship between the solenoid pack and the
side mount bracket. Run the four cables
and black thermal relay ground wire
through the bracket along with the four
mounting studs as shown. Place a flat
washer, lock washer and nut onto each
stud and tighten with a 10mm wrench.
Photo C. Fasten a machine screw with a
split lock washer followed by a flat
washer. Tighten all three solenoid
mount fasteners now.
Q-Series Winches feature two
mounting positions to suit your
individual application. The Above Side
Mount Installation features a Heavy
Duty Solenoid Bracket (Shown Right).
Some bumpers with Grille Guards or
Tubular Hoops require the Q-Series
Winch to Be installed using the Top
Mount Solenoid Brackets. To install
Winch with Top Mount Bracket, please
refer to page 4 for Installation.
Photo B
Photo A
Tighten both 6mm x 1mm x 12 mm
screws using a 5mm hex key.
Photo B. Fasten two socket cap screws
with split lock washer and flat washer
to attach the bracket to the winch base.
There are tapped holes on each side of
the motor mount. Do not tighten until
the third fastener is in place.
®
The Trusted Source
3
Photo C
Tighten the 6mm x 1mm x 12 mm
screw using a 5mm hex key.
Advertisement
