Advertisement
8
en | Wiring
Notice!
The D8132 Module is not UL Listed for "standalone" operation, and cannot be used in this
configuration for UL applications.
To determine the appropriate batteries for use with the module, see the table which displays
auxiliary current and battery recharge values for various battery Ampere-hour combinations in
the section Wiring for extending battery standby time and providing additional auxiliary current
output, page 6. (These values will vary depending upon the condition of the batteries
installed.)
For standalone power supply operation, install the module as shown in the following figure.
Figure 4.2: Wiring D8132 as standalone power supply
2018.05 | 4.0 | F.01U.036.305
1 AC branch circuit (unswitched)
2 D1640 transformer
3 D8132 module
4 Batteries
5 Devices
6 Gray wires connecting the D8132
7 Red wires from positive battery
8 Black wires from negative battery
Installation manual
Battery charger modules
module and the D1640 transformer.
terminals to the D8132LT module.
terminals to the D8132LT module.
Bosch Security Systems, Inc.
Advertisement
