Download Print this page

Bosch D8132 Installation Manual page 7

Battery charger modules

Advertisement

Battery charger modules
* GV3 and GV4 panels require a D1640 transformer. For legacy products refer to the control
panel documentation.
** The D8132 can support up to 27 Ah of backup battery. If two batteries are used they must
have the same Ampere-hour (Ah) rating.
Two cables are provided with the module for connections to the control panel and additional
batteries.
1.
2.
Warning!
Do not short these wires!
!
3.
4.
Warning!
Do not connect the grey wires to the control panel's transformer terminals.
!
5.
Notice!
Connect the D8132 and the control panel transformers to the same AC branch circuit. Do not
share the transformers with any other devices.
6.
7.
4.2
Wiring for standalone power supply
The D8132 module can operate as a 12 V standalone power supply. Standalone operation
does not have battery supervision or load shed, and therefore is not recommended for critical
loads requiring supervision.
Bosch Security Systems, Inc.
5 Control panel batteries (as needed)
7** Additional batteries (as needed)
9 Red wires from positive battery
terminals to the D8132 and the control
panel and from the D8132 to the
control panel
Connect the black wire of the four‑pin connector cable to the control panel's battery
negative terminal.
Connect the red wire of the four‑pin connector cable to the control panel's battery
positive terminal.
Plug the four‑pin connector cable into J1 on the module.
Connect the two grey wires to a separate 16.5 V, 40 VA transformer (D1640).
Connect the D1640 transformer to an unswitched 110-120 VAC 60 Hz outlet.
Plug the six‑pin connector cable into J2 on the module.
Connect a red wire to the positive battery terminal, and a black wire to the negative
battery terminal of each auxiliary battery. (One or two auxiliary batteries can be
installed.)
6 D8132 module
8 Gray wires connecting the D8132
10 Black wires from negative battery
Installation manual
module and the D1640 transformer
terminals to the D81132 and the
control panel and from the D8132 to
the control panel
2018.05 | 4.0 | F.01U.036.305
Wiring | en
7

Advertisement

loading

This manual is also suitable for:

D8132lt