Download  Print this page

Preparation For Servicing - Philips DVP620VR/04 Service Manual

Dvd + vcr combi.
Hide thumbs

Advertisement

Table of Contents

PREPARATION FOR SERVICING

How to Enter the Service Mode
About Optical Sensors
Caution:
An optical sensor system is used for the Tape Start
and End Sensors on this equipment. Carefully read
and follow the instructions below. Otherwise the unit
may operate erratically.
What to do for preparation
Insert a tape into the Deck Mechanism Assembly and
press the PLAY button. The tape will be loaded into
the Deck Mechanism Assembly. Make sure the power
is on, connect TP501 (S-INH) to GND. This will stop
the function of Tape Start Sensor, Tape End Sensor
and Reel Sensors. (If these TPs are connected before
plugging in the unit, the function of the sensors will
stay valid.) See Fig. 1.
Note: Because the Tape End Sensors are inactive, do
not run a tape all the way to the start or the end of the
tape to avoid tape damage.
Q503
Q504
TP501 S-INH
Fig. 1
1-5-1
H9720PFS

Advertisement

Table of Contents

   Also See for Philips DVP620VR/04

   Related Manuals for Philips DVP620VR/04

Comments to this Manuals

Symbols: 0
Latest comments: