Servicing Dvd-Module & Mono Board; Replacing Dvd Module; Reprogramming Of New Mono Boards; Reset Of Virgin Mode - Philips DVD 950 Service Manual

Servicing DVD module and MONO board
8. Servicing DVD module and MONO board
8.1

Replacing DVD module

The DVD module(Basic Engine and the mono board) has to be
exchanged completely in case of failure. A new module for
8.2

Reprogramming of new mono boards.

Caution
This information is confidential and may not be distributed. Only a qualified service person should
reprogram the mono board .
After replacement of the mono board, all the customer settings and also the region code will be lost.
Reprogramming of the mono board will put the player back in the state in which it has left the factory,
i.e. with the default settings and the allowed region code.
Reprogramming is limited to 25 times
When the counter reaches 25, reprogramming is not possible anymore
Reprogramming will be done by way of the remote control.
Put the player in stop mode, no disc loaded.
Press the following keys on the remote control:
< PLAY > followed by numerical keys <1> <5> <9>
The display shows: " - - - - - - - - - - - "
Press now successively the following keys :
for DVD950/171 : <0><0><4> <0><0><0><0><0><0><0><0><0>
Press < PLAY > again.
The TV screen will become BLUE during a short time to confirm that the mono board has been
reprogrammed, then the set goes to standby mode.
8.3

Reset of Virgin Mode

After the player has been powered up for test by the dealer, it
would have gone through the Virgin Mode. It is possible to reset
the settings made during that mode before the delivery of
player to the customer. This can be done as shown in the
following diagram:
DISCONNECT FROM MAINS
PRESS 2 KEYS
SIMULTANEOUSLY
<PLAY> + <OPEN/CLOSE>
CONNECT TO MAINS
VIRGIN MODE IS RESET
TV SCREEN SHOWS
VIRGIN MODE MENU
Figure 8-2
CL96532126_023.eps
261099
DVD750/001 can be ordered with codenumber 3104 129
51980.
Return the defective unit complete assembled in original
package to Philips Consumer Service in Eindhoven
Figure 8-1
TRADE MODE
When the player is in Trade Mode, the player cannot be
controlled by means of the front key buttons, but only by means
of the remote control.
IF TRADE MODE OFF
DISCONNECT FROM MAINS
PRESS 2 KEYS
SIMULTANEOUSLY
<PREVIOUS> + <OPEN/CLOSE>
CONNECT TO MAINS
PLAYER IS IN TRADE MODE
WHEN PRESSING FRONT
KEYS, THE PLAYER
DOESN'T RESPOND
DVD 950 8.
CL 96532126_026.eps
291099
IF TRADE MODE ON
DISCONNECT FROM MAINS
PRESS 2 KEYS
SIMULTANEOUSLY
<PREVIOUS> + <OPEN/CLOSE>
CONNECT TO MAINS
PLAYER IS IN NORMAL MODE
WHEN PRESSING FRONT
KEYS, THE PLAYER WILL
RESPOND
CL96532126_024.eps
Figure 8-3
GB 53
261099