Philips DVP620VR/04 Quick Use Manual

DVP620VR_00-Eng_rev2 10/1/04
-
-
There are many ways to connect your new DVD / VCR to your Television and other equipment.This Quick-Use
Guide shows the easiest, most common connection.
Higher quality connections are explained in the accompanying owner's manual and will provide better sound or
picture if your TV and / or audio system is compatible.
ANTENNA or
4
CABLE TV SIGNAL
DIGITAL
AUDIO OUT
OPTICAL
1
Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only after you
have finished hooking up everything. Never make or change connections with equipment connected to the power outlet.
2
Connect your existing RF cable from the Antenna TV signal directly to the AERIAL jack on the rear of the
DVD/VCR using an RF cable (not supplied). If you have a Cable Box (or Satellite Receiver), connect the OUT jack of
the Cable Box/Satellite Receiver to the AERIAL jack on the DVD/VCR using an RF coaxial cable (not supplied).
3
Connect the supplied black RF coaxial cable to the DVD / VCR's ANT -OUT jack and to your TV's ANTENNA
IN jack. The TV's ANTENNA IN jack may be labelled 75-ohm,TV IN, or RF IN. Check your TV manual for details.
4
Plug the power cords of the DVD / VCR,TV and Cable Box (if applicable) to a power outlet.
5
Turn on the TV power. Set the TV to a video channel. (See the accompanying DVD /VCR owner's manual for
details.)
6
Press the STANDBY-ON 2 button on the DVD / VCR or its remote to turn on the DVD / VCR. The first
time you turn on the DVD/VCR, you should complete the VCR setup. See the other side of this Quick-Use Guide for
details.
16:48 Page 1
D VP620VR
CABLE BOX
(Optional)
IN
OUT
DVD
ANALOG S-VIDEO
AUDIOOUT OUT
VCR AV2(DECODER)
L
DVD/VCR AV1(TV)
COAXIAL
R
ANTENNA or
CABLE TV SIGNAL
2
OR
RF COAXIAL CABLE
AERIAL
RF OUT
SCART IN
3
SCART IN