HP 3000 Installation Manual page 4

PREFACE
This manual describes the installation of an HP 3000 Series 37 Computer system.
It
is intended for use by
Hewlett-Packard Customer Engineers trained on the HP 3000 Series 37 computer systems.
Before the system can be installed, the site must be adequately prepared, as described in the HP 3000
Series 37 Site Planning and
Preparation Guide, part number 30457~90008.
The following information can be helpful in installing the system.
HP-IB Diagnostic Manual Set PN 30070-60068
CE Handbook PN 30070-90010
Diagnostic/Utility System Reference Manual PN 30070-90043
MPE System Utilities Reference Manual PN 30000-90044
System Operator and Resource Management Reference Manual PN 32033-90005
Series 37 Installation Video Cassette PN 90304HZ
Service and Installation manuals for the peripheral devices installed with the system should be taken on
site if familiarity with the device is limited.
This manual is organized as follows:
Section I - Defines Hewlett-Packard and Customer responsibilities in receiving the system.
Section 2 - Describes the mechanical and electrical characteristics of the System Processor Unit (SPU) and
the I/O Extender.
Section 3 - Provides general installation instructions for the system hardware.
Section 4 - Provides system and peripheral turn -on procedures.
Section 5 - Provides system configuration and verification information.
Section 6 - Lists the topics that should be covered when familiarizing the new system operator with the
system.
Section 7 - Lists the steps in upgrading the Series 37 customer-installable system to the Series 37XE
system.
Appendix A - Provides information for cabling terminals and modems to the Series 37XE system.
0984
v