Installing The System Cabinet; Connecting The Spu To The I/O Extender - HP 3000 Installation Manual

System Installation
INST ALLING THE SYSTEM CABINET
Install the system cabinet as follows:
I
CAUTION
I
The cabinet is front-heavy and unstable when the legs are raised. Do NOT
sit on the cabinet and do NOT push it from the rear or sides.
1.
Position the cabinet in an area that allows access to the cabinet door and AC power receptacle,
and allows the removal of the sides of the cabinet.
2. Secure the cabinet by lowering the four legs to the floor.
CONNECTING THE SPU TO THE 1/0 EXTENDER
Connect the SPU to the I/O Extender using the following procedure.
1.
Remove the key from the keyswitch.
2. Using a number 0 Phillips screwdriver, loosen the, two captive screws at the top corners of the
SPU front panel and remove the front panel.
3. Using a number 1 Pozidriv screwdriver, remove two screws and remove the SPU cover plate.
The cover plate is located at the bottom of of the SPU. Save the screws.
4. Using a number 0 Phillips screwdriver, loosen the two captive screws at the top corners of the
I/O Extender front panel and remove the front panel.
S. If mounting feet are installed on either unit, remove them as follows:
a. Press down on the rear tab of the mounting foot until the tab is released from the card
cage.
b. Push the mounting foot to the rear of the card cage until it is released from the card
cage.
6. Place the I/O Extender on a work surface and set the SPU on top of it. Align the rear tabs on
the Extender with the slots in the SPU.
7. Slide the SPU forward and lower it onto the Extender. Align the front tabs on the "Extender
with the slots in the SPU.
8. Using the screws saved above, fasten the SPU to the Extender.
0984
3-9