Selecting The Operating Mode - Siemens AOP Operating Instructions Manual

Start
Stop
The key does not function in the broadcast mode since parameters cannot
be edited on a global basis.
The and
be possible to change the speed of the motor simultaneously across all
connected inverters.
4.2.2 Communications Failure
If at any time, communications fail between the AOP and a connected slave
inverter, a 'Slave Error' warning screen is displayed. This screen will indicate
which slave inverter is not working correctly.
The key must be pressed to acknowledge the fault condition.
Should the fault condition occur again, then the user will be returned to the Main
Menu and will not be allowed to enter the 'local' Operate mode.
5

Selecting the Operating Mode

The Mode Menu allows the user to select the required operating mode of the
AOP. The modes supported by the AOP are listed below:
To exit a selected mode either follow the on screen instruction or select Mode
from the top level menu and change to a different mode of operation.
A summary of the various modes and their limitations is contained in the table
below.
When changing the mode of the AOP, the user is always presented with a
confirmation screen.
Press to confirm the selected mode.
Press to return to the Main Menu.
LOCAL MASTER
Operate Operate
Diagnostics Diagnostics
Parameters Parameters
Mode
Upread
Download Download
Language Language
Setup
Timer
The various modes are selected from the Main Menu using the following
procedure:
AOP Operating Instructions – Issue 07/05
6SE6400-5AP00-0BB0
keys still function in broadcast mode. For example, it would
LOCAL
MASTER
INTERNAL
SLAVE
PC mode
MM3 Upload (see Section 5)
INTERNAL
Diagnostics
Parameters
Mode Mode
Upread
Language
Setup Setup
Timer Timer
Engineering
PC
SLAVE
Mode
Mode Mode
MM3
Upload
Mode
Upread
Language
Setup
21