Rack Mount Safety Considerations; Two-Post Installation - Dell Virtual Edge Platform 4600 Setup Manual

NOTE: The illustrations in this section are not intended to represent a specific
platform.
NOTE: Do not the use the mounted two-post rails as a shelf or a workplace.

Rack mount safety considerations

• Rack loading—Overloading or uneven loading of racks may result in shelf or rack failure,
possibly damaging the equipment and causing personal injury. Stabilize racks in a
permanent location before loading begins. Mount the components starting at the bottom
of the rack, then work to the top. Do not exceed your rack's load rating.
• Power considerations—Connect only to the power source specified on the unit. When
you install multiple electrical components in a rack, ensure that the total component
power ratings do not exceed the circuit capabilities. Overloaded power sources and
extension cords present fire and shock hazards.
• Elevated ambient temperature—If you install the platform in a closed rack assembly, the
operating temperature of the rack environment may be greater than the room ambient
temperature. Use care not to exceed the 45°C (113°F) maximum ambient temperature
of the platform.
• Reduced air flow—Do not compromise the amount of airflow required for safe operation
of the equipment. Install the equipment in the rack so that the equipment constantly has
the correct amount of airflow surrounding it.
• Reliable earthing—Maintain reliable earthing of rack-mounted equipment. Pay particular
attention to the supply connections other than the direct connections to the branch
circuit, for example; use of power strips.
• Do not mount the equipment with the fan panel facing in the downward position.

Two-post installation

To easily configure your rack for installation of the VEP4600, use the two-post rack
mounting system provided. To complete this installation, supply four rack-mounting screws.
NOTE: To be NEBS-compliant, you must install the VEP4600 in a four-post rack.
To begin installation, separate each rail assembly by sliding the inside rail out of the outside
rail.
NOTE: For more installation instructions, see the installation labels attached to the
rail assembly.
VEP4600 installation 13