Fence Facing - RIDGID TS 2400 Operator's Manual

Fence Facing

Select a piece of smooth straight wood
approximately 3/4 inch thick, and the
same length as the rip fence.
Attach it to the fence with the three square
head bolts, nuts and washers. (See
"Hardware for Attaching Wood Facing") in
Repair Parts Figure 4. To remove the fac-
ing, loosen the hex nuts, slide the facing
toward the rear and out of the fence slot.
If the fence facing is for use with feather
boards, it will need to be about 8" tall. For
use with molding heads and dado blades
the width should be at least 3".
Square Head
3/4"
Bolt
Flat
Counterbore
Washer
3/4 Diameter
x 3/8 Deep
3"
Hex
Minimum
9/32
Nut
Diameter
Hole
1-3/8
Lockwasher
Fence
Wood Facing
41