Table of Contents
Advertisement
2.2.3
Button Installation (AntumbraButton)
Individual buttons can be disabled if a particular panel location does not require all six
buttons to be used. By using the blue switches and buttons, mechanical action can be
switched on or off.
Disable the mechanical action of unused buttons by setting the blue switch to OFF.
After ensuring that the correct buttons are enabled or disabled as required, attach the
buttons to the application module. Carefully line up each button with the application
module, then press the center of the button until it clicks into place. Press each side of the
button into place.
Once correctly attached, enabled buttons will have a smooth tactile click when pressed. If
any enabled button does not have a positive click when pressed, check for obstructions or
the disable switch being set incorrectly.
Antumbra
Off
21
13 October, 2017
On
Installation
Advertisement
Table of Contents
