Table of Contents
Advertisement
To separate the communication module and application module,
use a small screw driver to gently unlock the two clips on either
side of the communication module.
The mounting plate fits any standard size European wall box or a wall cut out of 51mm x
51mm. If using wall mounting then the smaller base mounting screw locations should also
have a small indent behind them, made into the wall so there is no interference from the
screws while mounting the panel. The Mounting box must have a depth of 33mm to contain
all the panel components and network cabling. Remember that there will be a need for two
network cables in the wall box.
1. The mounting plate needs to be installed with the locating tabs into the wall.
2. The network cables and connector plug pulls though the mounting bracket.
3. The plate's orientation can be either way. Using the long mounting screws provided, fix
the mounting bracket to the wall. Installers must use the screws provided as different
screws could damage the panel once fully installed.
4. Ensure that the mounting plate is level and adjust if required.
Antumbra
1
2
18
13 October, 2017
3
Installation
Advertisement
Table of Contents
