Tap Tempo - Hotone Binary Mod Owner's Manual

Tap Tempo

Hold the PATCH/TAP footswitch to engage Tap Tempo mode when the effect is on. Then tap the PATCH/TAP footswitch to set a tempo speed.
In this mode, the LED under the RATE knob will pulse to indicate the effect rate you set. Hold the PATCH/TAP footswitch again to disengage.
In Tap Tempo mode, turn the RATE knob (or any related knobs) to set a proper tap tempo subdivision shown as below:
SUBDIVISION
Whole Note
Half Note
Dotted Half Note
Half Note Triplet
Quarter Note (no division)
Dotted Quarter Note
Quarter Note Triplet
8th Note
Dotted 8th Note
8th Note Triplet
16th Note
Note: 1. The default division is Quarter Note (1/4, no division). Disengaging Tap Tempo function will reset the subdivision to default.
2. Tap Tempo subdivision function requires firmware v1.1.2 or later.
DESIGN INSPIRATION
DIVIDE RATIO
4
2
3
4/3
1/1
3/2
2/3
1/2
3/4
1/3
1/4
DISPLAY
1
1/2
1/2D
1/2T
1/4
1/4D
1/4T
1/8
1/8D
1/8T
1/16