Advertisement
5141 POMMEL HORSE
3. Turn the Locking Handles on the Pedestal Uprights counter-clockwise until they are completely
loosened. Make sure the 'V' shape in the blocks faces towards the adjusting shaft.
4. Open the Horse Top carton and remove loose Pommels and Pommel hardware.
Two people are required for removing the horse from the box and assembling it to the
base.
5. Pre-Assemble the Horse Top by attaching the mounting plate and adjusting tube assembly (Fig.
2).
•
DO NOT FULLY TIGHTEN
properly when placed on the base. Once this is done then screws must be fully tightened.
• Be sure to use the correct holes.
• Short side of plate faces out towards the ends.
• Refer to illustration below for assembly.
Short side of mounting
plates face out towards
the ends.
6. Lower the Horse Top Pre-Assembly carefully until they slide into the pedestal uprights (Fig. 3).
7. While holding the Horse Top, pull the Snap Locks to allow the adjusting tubes to pass deeper
into the Pedestal Uprights (Fig. 3).
The Horse Top has the potential to drop. Injury can occur as a result of this dropping.
Stay well clear of the Adjusting Tubes!
8. Set the horse at FIG height to release the Snap Locks and tighten both Locking Handles
securely.
Page 4 of 9
SCREWS. Screws will need to allow the adjusting tubes to line up
DO NOT USE
the
holes marked
with an "X"
Figure 2 – Horse Top Pre-Assembly
Assembly Instructions
DO NOT FULLY TIGHTEN
SCREWS (8)
until after top has been
placed on the base. Mounting plates
will line up when adjusting tubes are
put inside base tubes.
Advertisement
