Dynojet Power Commander V Installation Manual page 5

FIG.G
12 Locate the stock O2 sensor connection.
This is a BLACK 4 pin connector located on the left hand side of the frame next to
the fuse box.
13 Unplug this connection and plug the Dynojet O2 eliminator into the stock
wiring harness (Fig. G).
The stock O2 sensor will not be onnected to anything.
14 Reinstall the fuel tank, side cover and seat.
Speed input - BLACK wire of speed sensor. Connector is behind the left side
panel near the O2 sensor connection.
Temperature input - BLK/BLU wire of temperature sensor on backside of cylinder
between #1 & #2.
12v source for Auto tune - GREY wire of tail light plug.