Download
Share
Print this page
Dynojet Power Commander V Installation Manual
  1. Manuals
  2. Brands
  3. Dynojet Manuals
  4. Automobile Accessories
  5. Power commander V
  6. Installation manual

Dynojet Power Commander V Installation Manual

2007-2008 yamaha r1
Hide thumbs Also See for Power Commander V:
1
2
3
4

Advertisement

Quick Links

Download this manual See also: Installation Instructions & Owner's Manual, Installation Manual
2007-2008 Yamaha R1
I n s t a l l a t i o n I n s t r u c t i o n s
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
22-036
www.powercommander.com
2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
PARTS LIST
1
Power Commander
1
USB Cable
1
Installation Guide
2
Power Commander Decals
2
Dynojet Decals
2
Velcro strips
1
Alcohol swab
1
Posi-tap
THE IGNITION MUST BE TURNED
OFF BEFORE INSTALLATION!
THE LATEST POWER COMMANDER
SOFTWARE AND MAP FILES CAN BE
DOWNLOADED FROM OUR WEB SITE AT:
www.powercommander.com
2007-2008 Yamaha R1 - PCV - 1

Advertisement

loading
Need help?

Need help?

Do you have a question about the Power Commander V and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Dynojet Power Commander V

Summary of Contents for Dynojet Power Commander V

  • Page 1 Power Commander USB Cable Installation Guide 2007-2008 Yamaha R1 Power Commander Decals Dynojet Decals I n s t a l l a t i o n I n s t r u c t i o n s Velcro strips Alcohol swab Posi-tap THE IGNITION MUST BE TURNED...
  • Page 2 Crank- Do NOT connect anything to this port unless plug. instructed to do so by Dynojet. It is used to transfer crank trigger data from one module to NOTE: If you tin the wires with solder it will make another.
  • Page 3 FIG.A Remove the main seat. Prop the front of the fuel tank up. Route the PCV harness down the right hand side of the bike. bracket Loosen the bolts securing the fuel tank bracket to allow room for the PCV harness to fit underneath. Route the PCV harness underneath the fuel tank bracket as shown in Figure A. FIG.B Unplug the connector from the throttle bodies to the main wiring harness as shown in Figure B. This is the grey 12-pin connector. Ground wire FIG.C Attach the connectors from the PCV wiring harness to the stock connector as shown in Figure C. Verify these connectors are positioned to not interfere with the fuel line when the fuel tank is installed back into position. 22-036 www.powercommander.com 2007-2008 Yamaha R1 - PCV - 3...
  • Page 4 FIG.D Using the supplied Posi-tap, secure the GREY wire from the PCV to the WHITE wire of the ECU as shown in Figure D. This wire is from the smaller of the two ECU connectors in position five. The wire location is numbered on the back of the connector. FIG.E Attach the ground wire from the PCV to the negative side of the battery as shown in Figure E. 10 Using the supplied velcro, secure the PCV to the top, rear part of the ECU as shown in Figure F. Make sure to clean both surfaces with the alcohol swab before attaching. 11 Tighten the fuel tank bracket bolts. 12 Lower the fuel tank and reinstall the seats. grey wire Tuning Notes This bike uses a fly-by wire system, so conventional tuning can not be performed for...