Assembly - RIDGID R7120 Operator's Manual

ASSEMBLY

WARNING:
The tool should never be connected to a power
supply when you are assembling parts, making
adjustments, cleaning, performing maintenance, or
when the tool is not in use. Disconnecting the tool
will prevent accidental starting that could cause
serious injury.
INSTALLING AUXILIARY HANDLE
See Figure 2.
An auxiliary handle is packed with the drill for ease of opera-
tion and to help prevent loss of control. The auxiliary handle
may be installed at three different positions on the drill body.
To install the auxiliary handle:
Insert the threaded end of the handle into one of the three
positions on the drill as shown in figure 2.
Tighten the auxiliary handle at the desired angle by turn-
ing the handle clockwise.
To prevent thread damage and possible loss of control, the
auxiliary handle should be checked periodically for tightness.
Do not operate the drill with the handle loose.
INSTALLING SPADE HANDLE
See Figure 3.
A two-position spade handle is packed with the drill for ease
of operation and to help prevent loss of control.
To install the spade handle:
Place handle either vertically or horizontally on the mount-
ing boss, located on the rear end of the drill.
Turn the cap screw clockwise and tighten securely. Do not
over tighten.
To prevent thread damage and possible loss of control, the
spade handle should be checked periodically for tightness.
Do not operate the drill with the handle loose.
9
R
Fig. 2
Fig. 3