Chainway C70 Quick Manual

双面四色印刷 尺寸A4 (297x210mm) 三折页
07
battery capacity and battery life, the increase of the
NFC
internal resistance, and battery bulge etc.
• If the battery is unused for an extended period, to
NFC is a convenient, secure, wireless connection
avoid over discharge, please keep the battery level
technology can achieve rapid communication for
at 40% to 60% and store at room temperature. And
payment, ticketing, electronic ticket, smart media,
charge the battery once every 3 months.
data exchange and transmission functions.
• If the storage time is more than one year, one
Go settings → Wireless and networks →
charge cycle to activate the battery every year is
More ,open NFC and Android Beam，then 2 NFC
recommended.
devices could proceed data communication. For
(One charge cycle is a period of use from fully
more NFC functions , need third party software.
charged, to fully discharged, and fully recharged
again.)
08
USB CONNECTION • The estimated life of the battery is 300 charge
cycles, after reaching this limit, the capacity is
expected to shrink.
C70 can be connected
with PC or laptop through
USB port for synchroniza-
tion. There are three
options can be selected
for user's requirement.
USB related precautions：
Shenzhen Chainway
• Please connect to the USB port on the back of the PC.
Information Technology Co., Ltd
• Please do not use USB extension line or USB hub.
• Please do not share with other USB devices.
Support Contact Details
Battery related precautions:
Contact Us for Any Issues or Inquiries:
• Please charge the battery only with original adapter.
Service Call:
• If the battery is unused for an extended period, the
0086 - 755 - 23223300 (Switchboard)
over discharge situation will lead to the decrease of
0086 - 755 - 23223300 - 8103 (After-sale Service)
0086 - 755 - 23223300 - 8006 (Technical support)
Service Email:
service@chainway.cn
01
2
4
3
C70 device configuration: 2D barcode scanning
module, NFC, Camera (rear), 4G (NA), GPS,
Bluetooth, WIFI, 2G RAM, 16G ROM.
2
3
4
C70
5
6
HANDHELD COMPUTER 7
QUICK GUIDE
双面四色印刷 尺寸A4 (297x210mm) 三折页
APPEARANCE OF EQUIPMENT
02
CARD SLOT
Insert the SIM tray ejector to pin slot as the
direction shared below，after push the slot will
move upward and the SIM card slot and SD card
1 Iris light 8 Iris camera (rear) slot will be available .
9 Iris light
Iris camera
10 Scan Button
Menu Button
11 Card rack slot
Light sensor, distance sensor
12 Flash Light
Home Button
13 Power
Scan Engine
14
Back Camera 14 Setup
15 NFC
03
START UP / SHUT DOWN
1. Long press the power button for 2
seconds to power on or off the
6
device.
2. Short press the power button to
get into sleep mode or wake up
7
the device.
Power Button
8
9
04
12
CHARGE
13
14 Type-C
15 Use the adapter connected to
Type-C cable to C70 device
to charge.
05
SCANNING
2D Scan engine：
The scan engine is professional
1D/2D barcode scan engine，press
the scan button to activate the scan
engine using red laser beam to scan
1D/2D barcodes.
Scan Button
06
WIFI CONNECTION
Micro SD
1 C70 has adopted Andriod 6.0 OS, it
card
can be operated as smartphone.
WIFI connection can be adjusted by
WiFi
2 SIM Card
general setup option.