Accessories - Max ER-2700 Instruction Manual

Never disassemble or modify this instrument. It could cause a fire, electric shock, or
other problems.
● Do not insert foreign substances such as fingers, pens, wire, or paper into this in-
strument. It could damage the instrument or cause a fire.
● Use correct supply voltage. Other voltage level could damage the instrument.
● Do not splash water or chemicals on the instrument. If water gets inside the in-
strument, disconnect a power plug immediately from a plug socket and contact your
dealer/distributor for a repair. It could damage the instrument or cause a fire or
electric shock.
● Do not put paper or cloth on the instrument. It could cause a fire.
● Do not place any heavy material on a power cord. It could cause damage or a fire.
● Never touch a printer head. It is very hot just after printing and you could get
burned. Also, dirt on your hand could cause trouble to the printer head.
● When the instrument is not going to be operated for a long period of time, be sure to
disconnect a power cord from a power socket for your safety.
● When disconnecting a power cord, be sure to hold a power plug. Do not pull on the
power cord, or the cord could be broken and cause a fire or electric shock.

ACCESSORIES

This instrument comes with the following accessories. Confirm that they are included before using the machine.
1. Instruction manual
2700
INSTRUCTION MANUAL
: 1 booklet
☆Befo re using this instrument, study this manual to ensure
safety wa rn ing and instructions. Keep this instruction manual
w ith the instrument for futu re reference.
◆ Do not drop or hit the instrument.
◆ Install this instrument away from the following places:
1. Any place that is not level or that is subject to vibration.
2. Any place that has dust or high humidity. Keep beverages and liquid
containers away from this instrument.
3. Any place that the temperature goes below 0
4. Any place that catches direct sunlight or is located close to a heat source.
◆ Do not insert cards or paper other than the specified time cards for this in-
strument. Do not use time cards that are bent or torn.
◆ Be sure to use a dry cloth for cleaning. Do not use solvents (alcohol, ben-
zene, thinner, etc.) or a damp cloth.
◆ Do not re-ink cartridge. Replace with ink ribbon cassetteER-IR102E.
◆ Do not hang this instrument on a wall using anything other than the included plate for wall mounting.
◆ The socket-outlet shall be installed near the equipment and shall be easily accessible.
◆ A 30-minute break is required after continuous printing 15 minutes.
2. Screws for wall mounting
: 4-pcs.
/32 or over 40 /104 .
- 3 -